Automatic capsule filling machine steps
1, press the "power switch" in the green button, the power is turned on.
2, slowly adjust the "vibration intensity adjustment knob" clockwise rotation, at this time, "Vibrobearings" associated with the beginning as one of the finishing plate vibration plate finishing touch, the feel of the adjustment to a certain oscillation strength.
3, will be loaded into the capsule shell pink "loaded powder capsule shell finishing disk", each about to put about 300. The capsule cap into the "capsule cap finishing disk" around each about 300. Finishing plate with plexiglass plate, drilled many big small funnel-shaped hole, the hole diameter and the number corresponding to the diameter of the capsule.
4, about 30 seconds, the capsule shell and the capsule loaded powder that is falling into the hole in the cap, the opening facing up. In case of an individual when opening down, the available capsule gently press the cap down jacket, you can set out.
5, the level of handheld devices powder capsule shell-board, finishing in the lower part of the plate inside a little push, finishing disk loading powder capsule shell will fall down the hole in the adapter plate, then remove the access panel. The same method, the contact plate of the capsule out of the capsule cap cap.
6, can be prepared in advance a bottom area of 500 × 500mm2, the four sides of the powder height of about 10mm square plate, built-in powder, capsule shells will be fitted pink powder-board flat on the side of the disk. Then randomly assigned in a plexiglass box cover plate mounted powder capsules pick, shovel bucket with a small group of powder into the box, with a scraping edge of the box, then filled with powder, and scraped off the excess powder.
7, with a random distribution of the capsule cap suits board on the capsule cap connected to the board, there are holes on the position, it is easy to place. Flip capsule cap-board, the capsule opening down, sets have been installed in the loading powder pink capsule shell access panel, there are holes on the position, it is easy to set together.
8, will have nested capsule plate into the "capsule wearing a hat shaped board" below the cavity, pulled down by hand, "bar" and put in place without careful excessive force, because there is a positioning mechanism under the control pressure height. Remove the cover plate together capsule, the capsule can be poured.